Making/Buying a Cock Board

[schleg1]

Anyone have any advice on how I could get one? I have been searching for coffee tables and such but there's not much to go on. Getting a carpenter to build one for me cost about $200+ ... Any advice on where to look/buy/make?

[Mike-mike]

I went to lowes an bought a 24"x24" 3/8' thick board , I cut 2 -2' 2x8s and screwed then to it, then I put a 2x4 below that in the shape of an"t" , then I found the center and took s hole saw and drilled a 2" hole and snoothed the edges up, I works great, it im erect there's no way my balls can get back thru the hole, I'll try and post some pictures later , hope this helps

[sandalfan1]

I bought a 1/2"x10" pine board from the lumber store. I measured how tall I would be laying down and made it fit to size. I cut two pieces for the sides and screwed them together with 2.5" deck screws. Then I used a piece of 1"x1" along the corners to reinforce it and used 1.5" screws to hold those in place. I used a 2" hole saw and sanded the crap out of the hole and top of the board. Worked great, very lightweight, and easy to store because it isn't too big.

[Mike-mike]

Mine is big and hard to store, I don't want people to come over and see it and ask "what is that?"

[Net King]

Anyone have any advice on how I could get one? I have been searching for coffee tables and such but there's not much to go on. Getting a carpenter to build one for me cost about $200+ ... Any advice on where to look/buy/make?

Why have one at all? Partner can sit down and apply boots or sneakers as needed and they can reach those nice sensitive areas where it joins to the balls and between the balls and anus.

[schleg1]

Thanks for the tips. When you connect the legs onto the board how can you make sure that it's stable?

Why have one at all? Partner can sit down and apply boots or sneakers as needed and they can reach those nice sensitive areas where it joins to the balls and between the balls and anus.

I'm more into the stepping/stomping (See Julias Heels) and it'll be hard for a girl to balance with heels and on my dick

[daniel_privat68]

Well - located in a cock box - nearly unable to move - has a spcial thrill

[Mike-mike]

I used 3-1/2 inch wood screws . Drilled A pilot hole in the cockboard so it wouldnt crack, I put 4 on each side, it's super stable , I believe you could drive a car up on it and it would hold up